When bending tube or pipe, the bender must have enough bend arm toque to overcome a material's section modulus to make a bend into the tube that is permanent. ![]() However, section modulus can also relate to bending tubes. ![]() Typically, structural engineers designing “I†beams or T beams calculate section modulus of the cross-sectional area of the beam to understand if the beam will support a particular load or repeated cyclic loading. This is so that building, bridges, and rail road tracks do not fail and have safety factors. ![]() In particular, calculating the section area moment of inertia properties of common shapes for tube bending can be time-consuming and complicated. If you've ever had to perform the calculations necessary to properly bend tube and pipe you know that while they are a vital part of the bending process, there is often a lot of information to juggle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |